STANDARD NAUTICOOL AIR SYSTEM
Key Benefits
  • 22,000 BTU cooling capacity /  240 CFM Blower
  • 22 amp @ 12 Volt D.C. /  4-6 Horsepower draw
  • Heavy Duty Compressor meets U.S.C.G title 33 CFR 183.410 & J1171 standards
  • Evaporator 11” W X 13” H   X 11” D
*Engine Bracket set to fit Mercury 525     EFI has an additional charge
Compressor w/ engine mounting kit*
 
Condenser assembly w/ mount
 
Evaporator /  Blower assembly in a molded plastic case
 
Expansion Valve, Receiver Drier w/ mount, Refrigerant Hose w/ fittings, 3 air vents w/ 50 foot of 2.5 inch flexible vent tubing, Control switches w/ relay
________________________________________________________________
HEAVY DUTY METAL EVAPORATOR /  BLOWER ASSEMBLY
 
Highly suggested for Offshore, rough water, high speed boats.  Combination heat /  cool unit with optional heater core added.  Additional items: hose, controls, etc. necessary to install.  10”H X 15” W X 14” D

________________________________________________________________
BACK LIGHTED BLOWER COMPRESSOR CONTROL
 

This upgrade to the standard system adds the advantage of an illuminated membrane switch panel with micro processor relay control of the blower and compressor.

________________________________________________________________
SPECIAL ENGINE BRACKET SET FOR HP 525 EFI
 
This bracket kit is required for all HP 525 EFI engines.  Note if your boat is an O.S.S or A.P.B.A race boat.  The installation of this bracket kit requires resealing of the crank bolts.  NAUTICOOL AIR has been authorized by both associations to reinstall the safety wire at the crank and reseal with our own stamp and lead seal.  See tech rules from appropriate organization.  Below are examples of engines of different size and age with the NautiCool Air compressor mounted.  Please inquire about your specific mount kit.
 

________________________________________________________________
 

Descrption

SKU #
Standard A/C System

NC1
Metal Evaporator, Cool Only

MC100
Metal Evaporator, Heat and Cool

HC100
Illuminated Membrane Switch

MS13669
HP 525 EFI Bracket Kit

MB525

 

*Please call for pricing
________________________________________________________________
Engine Mount Kits
 
Below are examples of engines of different size and age with the NAUTICOOL AIR compressor mounted.  Please inquire about your specific mount kit.
________________________________________________________________

   

Mercury Marine HP 500 EFI

Mercury Marine HP 500 EFI
________________________________________________________________

  

Mercury Marine HP 525 EFI

Mercury Marine 496 H.O.
________________________________________________________________

 

Mercury Marine 260

Mercury Marine 502 MAG
________________________________________________________________